I was today doing some development in Visual Studio 2008 on a n-tier application, where some Webservice needed to be called that would then call some deeper layer on its turn, the usual stuff. However, the breakpoints in the DAL were not being hit and when stepping-in, the following error was shown: Unable to automatically step into the server. The remote procedure could not be debugged.This usually indicates that debugging has not been enabled on the server."
Turns out that this was caused by the web.config not having a
<
attribute. Therefore, any breakpoint located in a layer behind the service layer, was not hit. I remember having the same issue with Visual Studio 2005, but I never got this error however.
All content is property of www.snowball.be. Nothing on this site can be copied or published elsewhere, unless otherwise stated.
This site is made by Gill Cleeren.
Questions? Opinions? E-mail